|
Post by 41chevy on Apr 11, 2018 21:35:42 GMT -6
|
|
|
Post by 68383 on Apr 12, 2018 4:30:20 GMT -6
A couple might be:
- You chopped it (the roof in the 2nd picture looks much more squat, and the vent window looks to be at a different angle than stock) - Looks like the nose cone was grafted on to the front fenders instead of the gap with the typical black gasket - Shaved the door handles
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 12, 2018 11:24:31 GMT -6
It looks to me like the wing is shorter than usual.
|
|
|
Post by 41chevy on Apr 12, 2018 19:48:53 GMT -6
Roof is chopped and all 4 sides laid in. Wing is shortened and narrowed. Handles shaved Still 2 mods, both very major but very easy to over look.
|
|
|
Post by 68383 on Apr 12, 2018 19:51:27 GMT -6
How about the nose cone mod I mentioned?
|
|
|
Post by gardnerpag44 on Apr 12, 2018 21:44:18 GMT -6
Tucked in rear bumper and laid back windshield .
|
|
|
Post by 41chevy on Apr 13, 2018 13:10:44 GMT -6
How about the nose cone mod I mentioned? that and the odd rear bumper are both part of the other 2 mods, Smokey Unick would be proud of me.
|
|
|
Post by 41chevy on Apr 15, 2018 20:30:27 GMT -6
Roof Chopped with front and rear glass laid back. Shaved handles. Body sectioned 3mm. Body narrowed down the center 4mm. Wing modified to match.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 15, 2018 21:16:40 GMT -6
You can't see any evidence that the car was narrowed. How did you trim the glass to fit then?
|
|
|
Post by 41chevy on Apr 16, 2018 9:39:30 GMT -6
You can't see any evidence that the car was narrowed. How did you trim the glass to fit then? The back glass is flat so it was simply replaced with sheet. The windshield was cut on the outside edges. There is a mismatch with the fit you can see in one of the photos. The cuts in the body to narrow it was done by putting a piece os Saran Wrap inside and spraying in low expansion foam. I than cut the body in half on my table saw with a Dado Blade. Perfect matched cut to re glue and the Saran Wrap prevents the Foam from bonding to the body so it just pops out. Paul
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 16, 2018 12:47:09 GMT -6
Slick. Really slick.
|
|