|
|
Post by force1000 on Jan 31, 2011 7:26:31 GMT -6
hey guys, i have a question for anybody that can help me out. does anyone have any tips on making the injector lines & dist block on a top fuel motor  i hope someone can help, because this is driving me nuts  trying to build my own. any help would be great!! |
|
|
|
Post by 1320wayne on Jan 31, 2011 8:39:52 GMT -6
I have done plenty of these but I don't have any up close photos to show the detail so I will give you the next best thing. This diagram shows you where all of the lines need to go.  It's up to you as to what material you use for the distro. block and whether or not you want to do hard lines or tubing for the fuel lines. Hard lines are tougher because you have to have precise measurements to make it look right. I am including a few other diagrams to give you a better idea of doing a full detail job on a T/F or F/C engine.    |
|
|
|
Post by force1000 on Jan 31, 2011 8:53:57 GMT -6
thanks alot wayne this is gonna help me out a lot!!!
|
|
i hope someone can help, because this is driving me nuts 
trying to build my own. any help would be great!!